欲漫涩

A must have for any tuner enthusiast 鈥� the air intake system. All engines regardless of size and manufacturer require three ingredients for combustion: air, fuel and spark. Thus, increasing the airflow into an engine via an intake system will result in greater performance (horsepower), better throttle response and that signature suction noise.

Below, is a step-by-step explanation on how the KIA Forte Koup went from breathing through a metaphorical straw to this full air intake system provided by Turbokits.com

Preparation:

- Slide Outerwears pre-filer sleeve over intake filter

Step 1: Remove rubber hose connected to the air box pipe
- Carefully loosen and remove the rubber hose connected to the air box pipe.

- Next, slide off all clips around the air box

Step 2: Remove top portion of the air box unit

- Carefully wiggle the top portion of the air box unit and remove it along with the air filter inside it.

Step 3: Remove two (2) 10mm bolts securing intake feeder

Step 5: Install ECU bracket

- As part of the intake kit, a bracket is supplied to fasten the ECU unit securely. Use the supplied hardware consisting of three (3) nuts / bolts to secure the ECU to the bracket and tighten.

Step 6: Mount ECU unit with bracket in the factory position.

Step 8: Drop in intake aluminum pipe mating one end (with the breather end) to the throttle body and the other end tucked behind the left fog light.

Step 9: Apply the two (2) pieces of reflective heat tape to the radiator hose just under the intake pipe.

*Note: This step is not mandatory, but highly recommended.

Step 10a: Tighten all clamps

Step 10b: Install air hose (PCV vent) from the intake to the valve cover (male to male ends)

Step 11: Life vehicle to access splash shield, remove bolts covering the plastic undercarriage panel and move aside.

Step 12: Fit air filter onto aluminum intake pipe

Step 14: Re-assemble splash shield

Step 15: Test for secure fitment and that no pieces are loose. Start engine and rev a few times to assure that install does not interfere with any other parts of the vehicle.

听

Related Articles

RAM to return to NASCAR Trucks in 2026

After ending its NASCAR participation in 2012, RAM announced over the weekend that it will return to top-level stock car racing in 2026, with entries...

Toyota exec says next gen Celica project is in development

Now, before anyone reads that headline and gets too excited, there are caveats. Big ones. Firstly, the Toyota executive in question, Cooper Ericksen...

HEMI V8s dominate 2026 Dodge Durango lineup

At a time when Stellantis 鈥� parent company of the Chrysler brands 鈥� is rethinking its decision to deep-six HEMI V8 engines in the RAM 1500 and Dodge...

Bentley unveils a Bentayga with a drift mode

While Bentley鈥檚 press releases say it plans to be fully electric by 2035, internal combustion powered monsters with gigantic power output appear to be...

BMW unveils 523-horsepower M2 CS

Just when you thought BMW was taking a break from rolling out maximum performance track weapons, the Munich-based automaker announces another banger,...

RAYS Debuts New Matte Translucent Black Finish for the VMF C-01

RAYS has officially expanded the color options for its premium VMF C-01 forged wheel lineup with the introduction of a stunning new finish: Diamond...